Skip to content
ApplianceRepairListing

Appliance repair

Washer repair near you

Washer faults are usually mechanical rather than electronic, which keeps parts affordable. A drain, belt, or pump repair is often finished in a single visit — and a surprising share of no-drain calls turn out to be a coin in the pump filter.

673 of the 873 businesses in this directory list washer repair, across 50 states and 317 cities. Below them: what actually fails, what the repair costs, and when replacing is the better call.

Front-loading washer and dryer in a bright laundry room
Listed pros
673
States covered
50
Licensed
668
24/7 emergency
12
Average rating
4.6
Reviews
80,406
Advertisement

Top-rated washer repair pros

The 12 highest-rated of 673 businesses that service washers. Call the number on the listing — we never take a cut.

661 more washer repair businesses are indexed by state and city further down this page.

Advertisement

Common washer faults, and what each one usually is

Symptom, the cause it most often turns out to be, and whether it is homeowner work or a job that has to go to a licensed technician.

Washing machines fail in two distinct ways depending on their design. Top-loaders lose lid switches, motor couplers and transmissions; front-loaders lose door boot seals, drain pumps and bearings. Knowing which you have narrows the likely fault before anyone opens a panel.

The most expensive washer repair is the one nobody mentions on the phone: rear tub bearings on a front-loader. The symptom is a jet-engine roar on spin, and the job is usually a full teardown. On most mid-market machines it costs more than the machine is worth, which is exactly the conversation to have before paying a second diagnostic fee.

Homeowner fix
Safe for a homeowner with basic tools once the appliance is unplugged or the breaker is off.
Technician
Needs a technician — meter diagnosis, a model-matched part, or teardown that is easy to get wrong.
Licensed trade only
Gas piping, sealed refrigerant systems, or fixed wiring. Licensed and, for refrigerant, EPA Section 608 certified technicians only.
  • Fills and washes but will not drain

    Homeowner fix

    A blocked pump filter, a kinked drain hose, or a seized drain pump. On front-loaders the filter behind the lower access panel is the first place to look and is free to clear.

    Step-by-step: Washer Won't Drain
  • Drains but will not spin

    Technician

    A failed lid switch or door lock on a top-loader, or a stretched drive belt and worn motor coupler on a direct-drive machine.

    Step-by-step: Washer Won't Spin
  • Walks across the floor or bangs hard on spin

    Technician

    Worn suspension rods or shock absorbers letting the tub swing, or shipping bolts that were never removed at installation.

    Step-by-step: Washer Shaking and Walking
  • Water on the floor after every cycle

    Technician

    On a front-loader, a split or mouldy door boot seal. On a top-loader, the tub-to-pump hose or the inlet valve behind the machine.

    Step-by-step: Washer Leaking Water
  • Roaring or grinding that gets louder as the spin speeds up

    Technician

    Rear tub bearings. This is the one washer fault that regularly costs more than the machine is worth on a mid-market model.

  • Fills slowly or not at all

    Homeowner fix

    Blocked inlet screens at the hose connection, a closed shut-off valve, or a failed water inlet valve solenoid.

  • Clothes come out with grey smears and the drum smells

    Homeowner fix

    Biofilm in the boot seal and detergent drawer from cold washes and too much detergent. A maintenance problem, not a fault.

    Step-by-step: Washer Smells Musty
  • Trips the breaker or gives an electrical fault code

    Licensed trade only

    A failed motor, a shorted heater on a combo unit, or damaged fixed wiring at the outlet. Anything beyond the plug is electrician territory.

Maintenance that prevents those failures

Each item below maps directly onto a fault in the list above. This is the whole of washer preventive maintenance — there is nothing else worth doing.

  • Clear the drain pump filter

    Every 3 months

    Prevents: The most common no-drain call, and a pump killed by a lodged coin.

  • Run a hot maintenance wash with washer cleaner, drawer empty

    Monthly

    Prevents: Boot-seal biofilm, drum odour, and grey smears on laundry.

  • Wipe and dry the door boot and leave the door ajar

    After every wash

    Prevents: Mould in the seal — the single most common front-loader complaint.

  • Check the fill hoses for bulges and replace at 5 years

    Annually

    Prevents: A burst hose, which is the most expensive water damage event in the home.

  • Check the machine is level and stable on all four feet

    Annually

    Prevents: Suspension and bearing wear from an out-of-balance spin.

Try it yourself first

Free step-by-step guides and the replacement parts that fix most washer faults, with realistic difficulty ratings.

Washer parts & suppliers

Washer Smells Musty

easy45–90 minutes plus a cleaning cycle
Do it yourself
$10–$25
Hire a pro
$120–$250

11 more washer repair guides cover the rest of the faults above.

Common washer replacement parts with typical price, service life, and installation difficulty.
PartTypical priceDifficulty
Drain PumpLasts 8–12 years$30–$80moderate
Lid SwitchLasts 5–10 years$15–$40easy
Door Lock AssemblyLasts 6–10 years$40–$140moderate
Drive BeltLasts 8–12 years$15–$50moderate
Water Inlet ValveLasts 8–12 years$25–$85moderate
Shock Absorbers and Suspension RodsLasts 8–12 years$30–$100moderate
Motor CouplerLasts 6–12 years$15–$45moderate
Door Boot SealLasts 8–12 years$60–$190advanced
Tub Bearing KitLasts 10–14 years$35–$160advanced

Brands the listed washer pros service

Counts are how many of the 673 businesses servicing washers name that brand. 53 distinct brands are covered in total, and 34 of these businesses hold a factory-authorized servicer credential.

All brands →

Parts availability, not skill, is what limits washer repairs. Whirlpool, Maytag, GE and LG parts ship next day almost everywhere; Miele, Bosch and Speed Queen parts are usually ordered, so confirm the technician sources for your brand before booking.

Washer repair by state

50 states with listed washer repair businesses. Each opens a ranked list for that state.

Cities with the most washer repair pros

317 cities have at least one listed washer specialist. Ranked by how many.

Browse all locations →

Other appliances we cover

What washer repair costs

National ranges for parts and labor together, before the diagnostic fee. Regional labor rates move these by roughly 20% either way, and no figure here is a quote.

Typical washer repair jobs with national cost ranges.
RepairParts + labor
Clear pump filter or drain blockageFrequently just the diagnostic fee.$80–$160
Lid switch or door lock assemblyThe cheapest genuine part failure on a washer.$130–$250
Drive belt or motor couplerCoupler on a direct-drive top-loader is a designed sacrificial part.$150–$300
Drain pump replacementCheck for a lodged coin first — pumps are often blamed unfairly.$150–$350
Door boot seal (front-loader)Replace, do not patch; a mended boot leaks again.$200–$400
Suspension rods or shock absorbersAlways replaced as a set of four.$180–$400
Water inlet valveClean the inlet screens before condemning the valve.$150–$300
Tub bearingsOn most mid-market machines this exceeds the replace threshold.$400–$700

Blue Book

The 50% rule for a washer

New unit, US average
$800
Expected lifespan
11 years
Repair-or-replace line
$400
Diagnostic fee
$50–$100

A quote above $400 on a washer past 7 years old is usually money better spent on a replacement. Below that line, and with life left on the clock, repair wins almost every time.

Estimate my washer’s value

Adjusts for brand tier, age and condition. Free, no sign-up.

How long a washer lasts

10–13 years. Top-loaders with a mechanical transmission often outlast that; high-speed front-loaders trend lower because their bearings and boot seals carry more work per cycle.

Chronic overloading is the usual cause of a machine dying at year six. It loads the bearings, wears the suspension and leaves detergent that never rinses clear. Machines installed on a springy upper-floor deck without a solid base fail early for the same reason.

When replacing beats repairing

  • The quote is for tub bearings or a transmission on a machine past year eight.
  • The repair is over half the price of a comparable new machine.
  • The drum has cracked, or the outer tub is welded shut and the failed part is inside it.
  • It is the third repair in two years — the remaining components are all the same age.

Washer repair — common questions

How much does washing machine repair cost?
Typical washer repairs run $150–$350 including parts and labor, plus a $50–$100 diagnostic that is usually credited if you go ahead. Lid switches and belts sit at the bottom of that range; tub bearings at $400–$700 sit outside it and normally mean replacement.
Why won't my washer drain?
In order of likelihood: a blocked pump filter, a kinked or clogged drain hose, a broken lid switch on a top-loader that stops the drain cycle, then a failed drain pump. The filter and hose are both homeowner checks that cost nothing and resolve a large share of these calls.
Is a front-loader or top-loader cheaper to repair?
Top-loaders. Their common failures — lid switch, belt, motor coupler — are $130–$300 jobs. Front-loaders share the cheap failures but add the two expensive ones, door boot seals at $200–$400 and rear tub bearings at $400–$700.
How long do washing machines last?
10–13 years on average. Not overloading is the single biggest factor: an overloaded drum stresses the bearings and suspension every cycle and is the usual reason a machine dies around year six.
Why does my washer smell even though I clean it?
The odour lives in the door boot fold and the detergent drawer, not the drum. Wipe the boot dry after each wash, leave the door ajar, use the correct dose of HE detergent, and run a monthly hot maintenance wash. Cold washes with excess detergent are what feed the biofilm.
My washer shakes violently on spin — is it dangerous?
It will damage itself, and on an upper floor it can damage the structure. Check first that all four feet are down and locked and that any transit bolts were removed at installation. If it is level and still walking, the suspension rods or shock absorbers are worn and are replaced as a set.
Should I repair a washing machine that is 8 years old?
For anything under about $250, usually yes — you are buying two to five more years. For bearings or a transmission at that age, no: the quote will approach half the price of a new machine and the remaining components are all equally worn.

Need a washer fixed this week?

Every listing above is a real business with a real phone number. Compare two or three on rating, licensing and years in business, then call the one that explains the job best — and tell them what you found in the fault list above.